The effect of Si addition on the microstructure and tensile properties of casting Al-5.0Cu-0.6Mn-1.2Fe alloys.

In this work, we studied the effect of Si on the microstructure and tensile properties of the as-cast Al-5.0Cu-0.6Mn-1.2Fe alloys which were produced by casting with or without applied pressure. The results show that the addition of Si can significantly influence the microstructure and tensile properties of the alloys. For the alloys produced without pressure, the addition of Si can promote the formation of Chinese script {\alpha}-Fe, suppress the precipitation of plate-like Al3(FeMn) and Chinese script Al6(FeMn) and increase the volume percent of porosity, resulting in a remarkable decrease in the ultimate tensile strength (UTS) and yield strength (YS). For the alloys produced with a pressure of 75 MPa, the addition of Si can also promote the formation of fine Chinese script {\alpha}-Fe and high number density Al2Cu ({\theta}) phases, resulting in a slight increase in UTS and YS. The strength and elongation of the alloys increases with increasing applied pressure at the same Si level, which are attributed to the elimination of porosity, grain refinement strengthening and solid-solution strengthening. The alloy with addition of 1.1 % Si produced under the applied pressure of 75 MPa shows the best tensile properties, where the UTS, YS and elongation is 237 MPa, 140 MPa and 9.8%, respectively.